Does anyone know how to intercept RF Code 2. It is dimmable and I can change the color temp from cold to warm. The power supply that integrate the receiver is a shinlight electronic.
I have tried MiLightv1 protocol without success. I have looked a the PSU. I have not found a solution on my side. There might be a possibility with the RFLink on 2. I will try to see what kind of signal gets out of the microcontroller before the RF stage using an oscilloscope. I have not detected any signal. But I cannot confirm my wiring is OK for 2.
Bitrate seems to be around 33 kbps. Are you sure , I was thinking one remote can be paired on many light. Power on light and push A, B or C in the first 3 sec, then remote must be paired to the light.
Is it similar to. Project Reverse-Engineering the milight on-air protocol Hackaday. If it received x time the same frame at boot, it save the remote id or something like that. I have been playing with remote control programming according to the user manual to try to understand the system.
Next steps : It makes me believe that communication is unidirectional. My next steps will be to capture more oscilloscope traces to try to understand the frame format. I believe an intermediate common remote control solution would be use one original remote control together with an ESP or ESP32 to generate the correct IDs for each lamp to be controlled.
